Ceramizator CS-D Diesel Engine Oil Additive Ceramic Treatment 10g

Advanced Protection for Diesel Engines

Ceramizator CS-D is an engine oil additive designed to protect and revitalise diesel engines. It helps reduce friction, improve compression and extend the service life of engine components.

Its formula uses advanced nanoparticles with high surface activity to form a durable, stable ceramic-metal protective layer on metal surfaces. This layer provides a low coefficient of friction and excellent thermal conductivity, helping minimise wear and support engine performance.

The manufacturer states that the treatment provides protection for up to 62,000 miles / 100,000 km.

Key Benefits

• Helps regenerate and protect the engine and its components against wear.

• Forms a durable, highly resistant ceramic-metal protective layer.

• Reduces friction between moving engine components.

• Helps make cold starts easier and protects against dry starts.

• Helps improve cylinder compression.

• Helps reduce oil consumption.

• Supports smoother, more balanced engine operation.

• Helps reduce the risk of component failure.

• Helps decrease fuel consumption.

• Supports engine power, torque, efficiency and responsiveness.

Directions for Use

1. Warm up the engine for approximately 15 minutes.

2. Switch off the engine and add the recommended dose of Ceramizator CS-D through the engine oil filler opening.

3. Restart the engine and initially allow it to idle without driving. Follow the instructions supplied with the product for the required idling time.

4. Drive gently for the first 124 miles / 200 km, keeping engine speed at or below 2,500 RPM.

5. The manufacturer states that full protection is achieved after approximately 932 miles / 1,500 km.

Recommended Dosage

The required dose depends on the vehicle’s mileage and engine oil capacity.

Oil capacity equivalents: 2–10 litres = 0.53–2.64 US gallons; 10–20 litres = 2.64–5.28 US gallons; 20–30 litres = 5.28–7.93 US gallons.

Each pack contains one applicator.

Compatibility and Recommendations

• Designed for diesel-powered engines.

• Compatible with mineral, semi-synthetic and fully synthetic engine oils.

• Suitable for newer and older vehicles that have covered more than 1,000 km.

• Follow the supplied instructions and dosage table for the best results.

• Using less than the recommended dose may reduce the effectiveness of the treatment.

• Repeat treatment every 100,000 km, as recommended by the manufacturer.

• The manufacturer states that using Ceramizator does not invalidate the vehicle manufacturer’s warranty; check the applicable warranty terms before use.