Ceramizator CS-B Petrol Engine Oil Additive Ceramic Treatment 10g

Advanced Protection for Petrol Engines

Ceramizator CS-B is an engine oil additive designed to protect and revitalise petrol engines. It helps reduce friction, improve compression and extend the service life of engine components.

Its formula uses advanced nanoparticles with high surface activity to form a durable, stable ceramic-metal protective layer on metal surfaces. This layer provides a low coefficient of friction and excellent thermal conductivity, helping minimise wear and support engine performance.

The manufacturer states that the treatment provides protection for up to 62,000 miles / 100,000 km.

Key Benefits

• Helps regenerate and protect the engine and its components against wear.

• Forms a durable, highly resistant protective layer with a low coefficient of friction.

• Helps make engine starting easier and protects against dry starts.

• Helps improve cylinder compression.

• Helps reduce oil consumption.

• Supports smoother, quieter engine operation.

• Helps reduce the risk of component failure.

• Helps decrease fuel consumption.

• Supports engine power, torque, efficiency and overall performance.

Recommended Dosage

The required dose depends on the vehicle’s mileage and engine oil capacity.

Oil capacity equivalents: 2–10 litres = 0.53–2.64 US gallons; 10–20 litres = 2.64–5.28 US gallons; 20–30 litres = 5.28–7.93 US gallons.

Each pack contains one applicator.

Directions for Use

1. Warm the engine to normal operating temperature. The supplied instructions suggest driving approximately 2–5 km or allowing the engine to idle for 15 minutes.

2. Switch off the engine.

3. Add the recommended dose through the engine oil filler opening.

4. Restart the engine and allow it to idle for 15 minutes.

5. Drive gently for the first 200 km, keeping engine speed at or below 3,000 RPM. This distance can be covered in one journey, as recommended, or over several journeys during normal vehicle use.

6. After completing the initial 200 km, resume normal driving without the treatment’s engine speed restriction.

7. The manufacturer states that the full revitalisation and regeneration process takes approximately 1,500 km.

8. Do not change the engine oil during this 1,500 km treatment period.

Compatibility and Recommendations

• Designed for petrol engines.

• Compatible with mineral, semi-synthetic and fully synthetic engine oils.

• Suitable for newer and older vehicles that have covered more than 1,000 km.

• Follow the supplied instructions and recommended dosage for the best results.

• Using less than the recommended dose may reduce the effectiveness of the treatment.

• Repeat treatment every 100,000 km, as recommended by the manufacturer.

• The manufacturer states that using Ceramizator does not invalidate the vehicle manufacturer’s warranty; check the applicable warranty terms before use.